Riverbed SteelFusion Edge 2200 - Model Upgrades Using the Management Console

74 SteelFusion Edge Hardware and Maintenance Guide
Upgrading SteelFusion Edge Appliances Installing licenses and activating specifications
8. View the available model upgrade specification; enter the show hardware spec command:
amnesiac (config) # show hardware spec
Spec Description
- ---------- ----------------------------------------------------------------------
* SF3100W1 BW Limit: 30000 Kb/s Connection Limit: 2500
SF3100W2 BW Limit: 50000 Kb/s Connection Limit: 5000
(activation requires license)
SF3100W3 BW Limit: 100000 Kb/s Connection Limit: 10000
(activation requires license)
* = active
9. Stop the optimization service; enter the no service enable command:
amnesiac (config) # no service enable
Terminating optimization service.......
Note: You must stop the optimization service prior to model upgrade activation.
10. Activate the model specification; enter the hardware spec activate <model-number> command:
amnesiac (config) # hardware spec activate EXAMPLE-SF2100W2
Appliance upgrade to EXAMPLE-SF2100W2 successful
Note: Upgrades that require additional hardware automatically shut down the appliance after you activate the
model upgrade specification. Install the new hardware and power on the system. The system reformats the drives
and completes the upgrade.
11. Restart the optimization service for model upgrades that do not require a reboot, enter the restart
command:
amnesiac (config) # restart
Terminating optimization service......
Relaunching optimization service.
Note: After upgrading a model, you need to reapply admission control overrides relative to the default admission
control values of the new model.
Model upgrades using the management console
This section describes how to install a model upgrade license and activate the specification using the
SteelFusion Edge management console. For more information about using the Management Console,
see the SteelFusion Edge Installation and Configuration Guide.