SteelFusion Edge Hardware and Maintenance Guide
73
Installing licenses and activating specifications Upgrading SteelFusion Edge Appliances
Model upgrades using the CLI
This section describes how to install a model upgrade license and activate a specification using the CLI.
To install a model upgrade license from the CLI
1. Connect to the Riverbed CLI.
For detailed information about using the CLI, see the Riverbed Command-Line Interface Reference
Manual.
2. Enter enable mode; at the system prompt, enter the enable command:
amnesiac > enable
3. Enter configuration mode; at the system prompt, enter the configure terminal command:
amnesiac # configure terminal
amnesiac (config) #
4. View current and available model specifications; enter the show hardware spec command:
amnesiac (config) # show hardware spec
Spec Description
- ---------- ----------------------------------------------------------------------
* SF2100W1 BW Limit: 10000 Kb/s Connection Limit: 1500
SF2100W2 BW Limit: 20000 Kb/s Connection Limit: 2500
(activation requires license)
SF2100W3 BW Limit: 50000 Kb/s Connection Limit: 6000
(activation requires license)
* = active
5. Install the model upgrade license; enter the license install <license-key> command:
amnesiac (config) # license install LK1-MSPECSF2200W2-0000-0000-1-4A3A-1480-0CDF
Note: Riverbed recommends you write the license to memory after it has been installed.
6. Write the model upgrade license to memory; enter the write memory command:
amnesiac (config) # write memory
7. View licenses installed on the appliance; enter the show licenses command:
amnesiac (config) # show licenses
Local: LK1-SH10BASE-0000-0000-1-D2F9-EFAA-5244
Index: 1
Feature: SH10BASE
Valid: yes
Active: yes
Start date:
End date:
To Next Page
Loading...
