113
Line out socket (3.5mm Jack)
A 3.5mm Line Out socket located on the rear of your sound system is provided for connecting
the audio signal to an external amplifi er. Inserting an audio cable into this socket will not mute
the internal loudspeaker. Set the volume control on the sound system to minimum if desired.
Headphone socket
A 3.5mm Headphone Socket located on the rear of your sound system
is provided for use with headphones. Inserting a plug automatically mutes
the internal loudspeaker.
Please be aware that the sensitivity of headphones can vary widely. We
therefore recommend setting volume to a low level before connecting
headphones to the sound system.
IMPORTANT: Excessive sound pressure from earphones and headphones
can cause hearing loss.
To prevent possible hearing damage, do not listen at high
volume levels for long periods.
Inactive Standby timer
The Inactive Standby timer allows your sound system to save power by automatically going to
Standby if no controls are used for a period of time. By default this period is set to 8 hours but
you may change it if you wish.
1. With your sound system switched on, press and hold the Menu button to access the menu
for the current mode.
2. Press the Menu Up or Down buttons until 'System settings' is highlighted and press and
release the Select button.
3. Press the Menu Up or Down buttons until 'Inactive Standby' is highlighted and press and
release the Select button.
4. Choose from 2, 4, 6, 8 hours or Off. Your sound system will go into Standby after the selected
time has expired. Setting Inactive Standby to Off will disable this feature.
Note that if the sleep timer is used (see page 98) then the sleep timer will override this setting.
Off
2 hours
4 hours
6 hours
8 hours
Timeout
*
Backlight
Equaliser
Network
Time/Date
Inactive Standby
Language
System settings
To Next Page
Loading...
