13
Connecting to your computer network
Before you can use your Stream 65i sound system to listen to Internet radio or to music streamed from your
computer, it must fi rst be connected to your computer network.
This section of this book describes how to connect the sound system to your network using either the wireless
(WiFi) connection or the wired (Ethernet) connection.
The following instructions assume that you have just set up the clock and time options using the Setup Wizard
as described on the preceding page.
These instructions also apply to the Network Wizard in the Network Settings menu (from step 2 onwards).
1. The display will show a list of regional options for the WiFi confi guration.
Press the Menu Up or Down buttons to highlight the required region (for the UK choose 'Most of Europe'),
and then press the Select button to make the selection. Do this even if you are planning to use the wired
Ethernet connection. Your sound system will then scan for available WiFi networks.
2. The sound system will enter the Network Settings Wizard and will display 'Scanning...'. The sound system will
automatically scan both the 2.4GHz and 5GHz WiFi bands. After a short while the display will show a list of
the available WiFi networks. If you are intending to use the WiFi connection, go to step 3 on the next page.
To use the Ethernet connection to your router (with automatic confi guration), press the Menu Up or Down
buttons to point to the '[Wired]' menu item. Press the Select button and the sound system will attempt to
connect.
If your network allows automatic confi guration (which is normal) the sound system will acquire a network
address. The screen should say 'Connecting...', and then 'Setup wizard completed'. Press the Select button
to exit the setup wizard and show the Main menu. You can then skip to paragraph 10 on page 16.
[WPS]Smith
Jones
Paul’s network
[Rescan]
[Wired]
[Manual config]
SSID
Waiting for
Ethernet
Please wait
Network settings
Network wizard
Scanning...
Wlan region
Europe
To Next Page
Loading...
