116
Information
Factory reset
If you wish to completely reset your sound system to its initial state this may be
performed by following this procedure. By performing a factory reset, all user
entered settings will be erased.
1. To access the menu for the current mode press and hold the Menu button.
Press the Menu Up or Down buttons to highlight the 'Main menu' option,
then press and release the Select button to select.
2. Press the Menu Up or Down buttons until 'System settings' is highlighted
and then press and release the Select button to select.
3. Press the Menu Up or Down buttons until 'Factory reset' is highlighted and
then press and release the Select button. Press the Menu Up or Down
buttons and highlight 'YES' to proceed.
If you do not wish to carry out a system reset, highlight 'NO' and then press
and release the Select button. The display will revert to the previous menu.
4. With 'YES' highlighted, press and release the Select button. A full reset will
be performed and the sound system will restart as if fi rst plugged in. The
DAB stations list together with any preset stations will be erased and your
wireless network connection details will be lost. All confi guration settings
will be restored to their defaults, the clock and alarms will be reset.
In case of malfunction for any reason, reset the product as described above to resume normal operation. It
may be necessary in some cases to disconnect the mains power, then reconnect power after 10 seconds.
In case of malfunction due to electrical fast transient (burst), reset the product as above (reconnection of the
power source may be required) to resume normal operation.
When connecting the sound system to a router with an Ethernet cable, shielded cable is highly recommended.
The communication could be interrupted temporarily or noise may occur if using un-shielded cable and under
strong local interference (between 43 and 80MHz). Normal communication will resume automatically when
the interference signal is removed. FM radio reception may also benefi t from the use of a shielded cable.
1-3 1-3
1
1-4
SD
Bluetooth
Aux in
Sleep
Alarms
System settings
Main menu
Language
Rec. default dest.
Factory reset
Software update
Setup wizard
System info
System settings
Factory reset
Proceed?
Setup wizard
Start now?
Information
To Next Page
Loading...
