41
Dynamic Range Control settings
Dynamic Range Control (also known as DRC) can make quieter sounds
easier to hear when your sound system is used in a noisy environment
by reducing the dynamic range of the audio signal.
1. Press the On/Standby button to switch on your sound system.
2. Press the Radio button as needed to select DAB Radio mode.
3. Press and hold the Menu button to enter the DAB menu.
4. Press the Menu Up or Down buttons until 'DRC' is highlighted on the
display.
5. Press and release the Select button to enter the DRC adjustment
mode. The current DRC setting will be indicated with an asterisk.
6. Press the Menu Up or Down buttons to highlight the required DRC
setting (the default is Off).
'DRC Off' - DRC is switched off, Broadcast DRC will be ignored.
'DRC high' - DRC is set as sent by broadcaster.
'DRC low' - DRC level is set to 1/2 that sent by broadcaster.
7. Press and release the Select button to confi rm the setting.
Note: Not all DAB broadcasts use the DRC function. If the broadcast does
not provide DRC information, then the DRC setting in the sound system
will have no effect.
DAB Radio
DAB
radio
2
4,6 4,6
3
5,7
Station list
Scan
Manual tune
Prune invalid
DRC
Station order
DAB
DRC high
DRC low
DRC off
DRC
To Next Page
Loading...
