114
Auxiliary input socket
A 3.5mm Auxiliary Input socket located on the rear of your sound system is provided for
connecting the audio signal from an external audio source such as an MP3 or CD player.
1. Connect a stereo lead from the headphone output of your MP3 or CD player to the Aux
In socket located at the rear of the sound system. Typically this lead will have a 3.5mm
stereo plug at both ends.
2. Switch on your sound system.
3. Press the Radio button until AUX in mode is shown on the display.
4. Press the 'play' on the connected audio device. If you are using its headphone output for
the connection, set its volume control to a level of somewhere between two-thirds and
maximum (the objective is to get a strong audio signal but without too much distortion).
Then adjust the volume on the sound system as required.
Note: if using an iPod as the sound source, you may need to set its output to maximum
to get an adequate audio signal level.
5. After use, disconnect your player in order to listen to your sound system conventionally.
Mute function
Pressing the Mute button will mute the output from the loudspeakers.
1. Press the Mute button (on the remote control) to mute the sound output.
2. Press the Mute button again or one of the volume buttons to un-mute the sound output.
3
1,2
Display and Audio
To Next Page
Loading...
