Robopac MASTERWRAP PLUS XL FR - Front Stop Device Installation (Optional); Longitudinal Stop Device Installation (Optional)

42
INFORMATION ON HANDLING AND INSTALLATION
ENG
4.4.1. FRONT STOP DEVICE INSTALLATION (OPTIONAL)
1. Secure the stop device (A) to the base of the column with the screws supplied.
2. Drill the holes (ø10 x 70mm) on the floor in correspondence of the stop device fastening holes.
Important
Thoroughly clean the holes to eliminate any residual material.
3. Fix the stop device to the ground by means of plugs (B).
4.4.2. LONGITUDINAL STOP DEVICE INSTALLATION (OPTIONAL)
1. Position the stop device according to the shown diagram.
2. Drill the holes (ø10 x 70mm) on the floor in correspondence of the stop device fastening holes.
Important
Thoroughly clean the holes to eliminate any residual material.
3. Fix the stop device to the ground by means of plugs (B).