8.1.2. ALARM LIST (MASTERWRAP PLUS)
Emergency push-button
pressed
Reset by turning the button in the
direction of the arrow and press
“Reset”
Emergency plate at the
film carriage base
pressed alarm
Rotate the key-operated switch (G)
to “II” and press “START” to release
the film carriage
Opening of the film carriage
protection door
Close the film carriage door
Emergency bumper
pressed alarm
Contact of the rotary arm
with an obstacle
Remove the obstacle hindering arm
rotation
Emergency devices
disabled alarm
“Cycle start” button (B)
pressed with key-operated
switch (G) set to “I” or “II”
Set the key-operated switch (G) to
“O”
Film breakage during
wrapping cycle
Connect the film to the product and
press the “Cycle Start" button (B) to
complete the wrapping
A fault or an obstacle is
preventing the arm from
rotating
Check that the trajectory of the arm
is free from obstacles and the timing
sensor works correctly
A fault or an obstacle is
preventing the film carriage
from shifting
Check that the guides of the
carriage are not hindering its
movement. Check also the correct
operation of the high and low limit
switches
No pallet after the “Start
cycle” button (B) has been
pressed
Position the pallet and press the
“Cycle start" button (B) to wrap it
Carriage emergency
Bypass alarm
Key-operated switch (G)
set to “II”
Set the key-operated switch (G) to
“O”
Maximum number of
permitted actions in the
ECO cycle has been
exceeded (30 maximum
actions)
Record a wrapping cycle that does
not exceed 30 actions
Contact technical support
Carriage lifting motor
alarm
Contact technical support
Film unwinding motor
alarm
Contact technical support
Contact technical support
To Next Page
Loading...
