Robopac MASTERWRAP PLUS XL FR - Description of the Wrapping Cycles; Single Wrapping Cycle; Double Wrapping Cycle

ENG
INFORMATION ABOUT THE USE
87
6.12. DESCRIPTION OF THE WRAPPING CYCLES
6.12.1. SINGLE WRAPPING CYCLE
1. Turn the jog control to enable the wrapping cycle page.
2. Press the jog control and select the single wrapping.
3. Press the jog control to confirm.
4. The film carriage starts moving from the pallet base and stops when it reaches the upper end, after having
performed the required number of wrapping turns at the base and at the upper end of the pallet.
(See “Description of user interface”).
6.12.2. DOUBLE WRAPPING CYCLE
To select the “double cycle”:
1. Turn the jog control to enable the wrapping cycle page.
2. Press the jog control and select the double wrapping.
3. Press the jog control to confirm.
4. The film carriage starts moving from the pallet base, rises until reaching the upper end and moves down until
reaching the base, performing a double load wrapping.
(See “Description of user interface”).