Rockwell Automation Publication 2711R-UM001H-EN-E - April 2021 121
Appendix C Install and Replace Components
The battery is on the back of the terminals. No special tools are required to
remove the battery cover, but a flat-tip screwdriver may be required to remove
the battery.
WARNING: When you connect or disconnect the battery an electrical arc can
occur. This could cause an explosion in hazardous location installations. Be sure
that the area is nonhazardous before proceeding.
For Safety information on the handling of lithium batteries, including handling
and disposal of leaking batteries, see Guidelines for Handling Lithium Batteries,
publication AG-5.4
.
Do not dispose of battery in a fire or incinerator. Dispose of used batteries in
accordance with local regulations.
ATTENTION: Battery contains Perchlorate Material – Special handling may
apply.
See https://dtsc.ca.gov/perchlorate/
.
This perchlorate warning only applies to primary Lithium Manganese Dioxide
(LiMnO2) cells or batteries, and products containing these cells or batteries,
sold or distributed in California, USA.
Battery cover
This equipment is sensitive to electrostatic discharge (ESD). Follow ESD
prevention guidelines when handling this equipment.
Battery cover
Battery
This equipment is sensitive to electrostatic discharge (ESD). Follow ESD
prevention guidelines when handling this equipment.
To Next Page
Loading...
Need help?
General
