26 Rockwell Automation Publication 2711R-UM001H-EN-E - April 2021
Chapter 2 Configure the Terminal
4. Select the location to copy the alarm history from the To list, either USB
or microSD card.
5. Press Copy.
Change Controller Settings for an Application
You can change the network address or node address of the controller in your
application using the terminal. This feature is available in firmware revision
4.011 onwards.
Follow these steps to change the network address or node address of the
controller for your application from the terminal.
1. Go to the File Manager screen.
2. Press Controller Settings.
3. Press the blue area next to Address to change the address.
Copy Alarm History
Back
Copy
USB
From: PV800_App1
To:
Controller Settings
Back
Application Name: PV800_App1
Protocol: Ethernet | Allen-Bradley MicroLogix/ENI
Type: MicroLogix 1400
Address:
PLC-1 : 10.116.37.12
10.116.37.12
To Next Page
Loading...
Need help?
General
