Rockwell Automation Publication 2711R-UM001H-EN-E - April 2021 69
Chapter 3 DesignStation in Connected Components Workbench Software
Import Tags From a Micro800 Controller
Follow these steps to import Micro800 controller tags into your PanelView 800
application.
1. In the Tag Editor tab, click the Import.
2. In the submenu, select Micro800.
The Tag Selector dialog appears.
3. Select the tags you want to import, then click Import.
If the tags you want to import exists in your application, a warning message
appears. Click Yes to import all selected tags and overwrite existing tags, or No
to only import tags that do not exist in your application.
The Import tag result is show in the Output pane.
IMPORTANT
An error message appears if there is no Micro800 controller in
your project
To Next Page
Loading...
Need help?
General
