92 Rockwell Automation Publication 2711R-UM001H-EN-E - April 2021
Chapter 5 Virtual Network Computing
Set the Password for VNC Connection
The default VNC settings (no password) prevents you from establishing a VNC
connection to the terminal. You must set a view-only or control access
password before you can connect to the terminal with the respective access
rights.
Follow these steps to set a password for VNC connection to the terminal.
1. Press Enable/Disable to enable the VNC server.
2. Press Reset Password for either View-Only or Control access.
3. Type in the desired password using the on-screen keypad, then press
Enter.
IMPORTANT
Changing any VNC setting will terminate the current VNC connection to
the terminal. For example, if you are connected to the terminal in
control access and change the access to view-only, the VNC connection
will terminate and the next time you connect to the terminal you will be
in view-only access.
IMPORTANT
When you update the terminal firmware, the VNC password and settings
will be cleared and reset to their default configuration.
VNC Settings
Back
Server:
Access:
Server:
Status:
Access:
Enabled
View-Only
View-Only: Control:
Reset Password
Enable / Disable
View-Only / Control
Reset Password
VNC Settings
Back
Server:
Access:
Server:
Status:
Access:
Enabled
View-Only
View-Only: Control:
Reset Password
Enable / Disable
View-Only / Control
Reset Password
`
Esc F1 F2 F3 F4 F5 F6 F7 F8 F9 F10 F11 F12 Home End
1 2 3
4
5 6
7
8
9
0
- =
q w e
r
t y
u
i
o
p
[ ]
\
New Password:
Confirm Password:
Caps
a s d
f
g h
j
k
l
;
’
Shift
z x c
v
b n
m
,
.
/
Ctrl
Win
Alt
ins
del
To Next Page
Loading...
Need help?
General
