46 Rockwell Automation Publication 2711R-UM001H-EN-E - April 2021
Chapter 3 DesignStation in Connected Components Workbench Software
Install the Software To use the Connected Components Workbench software effectively your
computer should meet the following hardware requirements:
DesignStation in Connected Components Workbench software version 13 and
later is supported on the following operating systems:
• Windows® Server 2012 (64-bit) - requires .NET Framework 3.5 SP1 to be
installed
• Windows Server 2012 R2 - requires .NET Framework 3.5 SP1 to be
installed
• Windows Server 2016 - requires .NET Framework 3.5 SP1 to be installed
• Windows Server 2019 - requires .NET Framework 3.5 SP1 to be installed
• Windows 10 IoT Enterprise 2016 LTSB 64-bit- requires .NET Framework
3.5 SP1 to be installed
• Windows 10 IoT Enterprise 2019 LTSC - requires .NET Framework 3.5
SP1 to be installed
• Windows 10 (32-bit and 64-bit) (tested to Version 2004) - requires .NET
Framework 3.5 SP1 to be installed
Your computer information can be found by right-clicking My Computer and
then selecting Properties.
Follow these steps to install Connected Components Workbench software.
Connected Components Workbench software version 11 is used in the
following examples.
1. Run the executable file.
Minimum System Requirements
Component Requirement
Processor Intel Pentium 4 2.8 GHz or equivalent
RAM Memory 2 GB
Hard disk space 10 GB free
Optical Drive DVD-ROM
Pointing Device Any Microsoft Windows® compatible pointing device
Recommended System Requirements
Component Requirement
Processor Intel Core i5 2.4 GHz or equivalent
RAM Memory 8 GB or more
Hard disk space 10 GB free or more
Optical Drive DVD-ROM
Pointing Device Any Microsoft Windows compatible pointing device
To Next Page
Loading...
Need help?
General
