32 Rockwell Automation Publication 2711R-UM001H-EN-E - April 2021
Chapter 2 Configure the Terminal
After you have established an FTP connection to the terminal, you can copy the
contents of the folders out from the terminal to your PC. The FTP server on the
terminal is disabled by default.
Follow these steps to enable the FTP server.
1. Go to the Terminal Settings screen.
2. Press Communication.
3. Press FTP Settings.
4. Press Enable/Disable to enable the FTP server.
The Status now displays the text “Enabled”.
IMPORTANT
The terminal supports only one FTP connection. If another connection is
attempted, it is rejected and no notification is given. The behavior varies
from one FTP client to another.
IMPORTANT
An FTP connection cannot be established while the terminal is loading
an application. Wait until the application has finished loading before
connecting to the terminal.
IMPORTANT
It is recommended to download files from the terminal one at a time.
Also, set the connection inactivity timeout for your FTP client to 60
seconds or longer to avoid unsuccessful file download.
IMPORTANT
The FTP server feature is not available for CompactLogix™ 5370
controllers.
Communication
Disable DHCP
Set Static IP Address
VNC Settings
Port Settings
FTP Settings
Back
PV800T7T
0
Protocol: *
Status: Unavailable
Device Name:
Node Address:
IP Mode: DHCP
IP Address: 0.0.0.0
Mask: 0.0.0.0
Gateway: 0.0.0.0
MAC Address: XX:XX:XX:XX:XX
FTP Settings
Back
Enable / Disable
FTP Server:
Status: Disabled
To Next Page
Loading...
Need help?
General
