50 Rockwell Automation Publication 2711R-UM001H-EN-E - April 2021
Chapter 3 DesignStation in Connected Components Workbench Software
2. Click Next, then select the
components that you want to
uninstall.
Note to uninstall Connected
Components Workbench
software, you must first unselect
the checkboxes for the following
components:
• Drives - Unified Device
Configuration
• Graphic Terminals -
DesignStation
• Guardmaster® 440C Safety Relay
• 450L Safety Light Curtain
• Controller - Micro800
3. After you have unselected the
checkboxes of the components
that are listed above, you can
then unselect the checkbox for
Connected Components
Workbench software. Click
Install to proceed with the
uninstallation.
To Next Page
Loading...
Need help?
General
