Rockwell Automation Publication 1426-UM001J-EN-P - August 2019 207
Logic Functions Chapter 7
Commands
The following command parameters are found in the
Command.System_Registers
table on page 368.
Command Word Two
Set this command word value to execute the listed action. These values are the
selections:
6 = Clear Setpoint Log
7 = Clear Setpoint (Time) Accumulators
18 = Clear Setpoint Logic Gate (Time) Accumulators
Clear Setpoint Accumulators operates by using the value contained in this tag.
The default value is zero.
Clear Single Setpoint or Logic Gate Accumulator
0 = Clear all time accumulators
1…20 = Clear selected time accumulator
Related Functions
•Basic Metering
• Status Inputs
• KYZ and Relay Outputs
• Power Quality Monitoring
To Next Page
Loading...
