Instrument Functions
NRP2
98User Manual 1173.9140.02 ─ 07
Fig. 4-28: Measurement menu
●
Selecting a window, on page
92
●
Selecting a measurement function, on page
98
●
Selecting a unit, on page 106
●
Auxiliaries, on page 109
●
Relative measurement, on page 110
●
Limit monitoring, on page 111
●
Resetting auxiliary information, on page 112
4.4.2 Selecting a window
The window to be configured is selected by the tab.
Window dialog box tabs
Each window is assigned a tab. All the parameters settings in the "Window" dialog box
act on the selected window.
Remote command:
DISPlay[:WINDow]:SELect on page 246
With remote command there is a distinction between selecting the active window and
selecting the window to be configured. The active window is selected using command
DISPlay:WINDows:SELect. The window to be configured is selected with the suffix
of the WINDows keyword. For example DISPLay:WINDow3:NAME defines the label of
window 3.
4.4.3 Selecting a measurement function
In this chapter, measurement function are discussed that can be displayed in numeric
windows ("Dig", "D/A"). The functionality of the graphic windows is described in chap-
ter 4.5, "Displaying traces", on page 113
The R&S NRP2 can display the measurement result of one channel (sensor) or com-
bine measured values from two channels (sensors) using a mathematical function and
display the result in the selected window. The necessary settings are made in the
"Function..." dialog box.
Configuring measurements
北京海洋兴业科技股份有限公司（证券代码：839145）
To Next Page
Loading...
