Roland JUPITER-X - Bluetooth Management; Differentiating Multiple JUPITER-X Units; Disabling Bluetooth Functionality

22
I-ARPEGGIO
Operations in STEP EDIT
Item Operating the Unit
Move left/right between steps [1] knob
Change the velocity value [2] knob
Move vertically PAGE [
] [ ] buttons
Move between pages PAGE [<] [>] buttons
Exit step edit [EXIT] button
Specify the note Press a key
Specify a step and turn the note on [1]–[16] button
Turn the currently selected note
on/o
[ENTER] button
Enter a tie
Move the cursor to the beginning of the tie,
then hold down the [SHIFT] button and press
the [1]–[16] button corresponding to the last
step of the tie.
Move between parts
[PART] button 0 select the current part
Erase all data from the currently
selected part
[S1] button
Erase all data of the selected note While holding down a key + [S1] button
Erase all data of the selected step [1]–[16] button + [S1] button
Playing a Pattern You Entered
The data that you edit in STEP EDIT can actually be used for
arpeggio performance.
1. Press the [MENU] button.
2. Use the [1] knob to select “ARPEGGIO EDIT,” and then
press the [ENTER] button.
The ARP PART EDIT screen appears.
3. Use the [1] knob to select “Step Mode,” and set it to
“ON” or “KEYSHIFT.”
Parameter Value Explanation
Step Mode
ON
The notes are played according to the
arpeggio performance, as specied by the
pattern that you created in STEP EDIT.
KEYSHIFT
The notes are played according to the
arpeggio performance and playing
sound, using the pattern that you
created in STEP EDIT.