Roland JUPITER-X - Convenient Functions (UTILITY Screen); Backing-Up Data to a USB Flash Drive (BACKUP); Restoring Backed-Up Data; (Restore)

48
Backing-Up Data to a USB Flash Drive
(BACKUP)
Here’s how to back up user data to a USB ash drive.
Data that is backed up
5 All scene data (including arpeggio settings and step edit data)
5 User tone data
5 System settings
1. Connect a USB ash drive.
USB ash drive
2. Press the [MENU] button.
3. Use the [1] knob to select “UTILITY,” and then press
the [ENTER] button.
You can also make this selection by using the PAGE [ ] [ ]
buttons instead of the [1] knob.
4. Use the [1] knob to select “BACKUP,” and then press
the [ENTER] button.
The BACKUP screen appears.
5. Use the PAGE [<] [>] buttons to move the cursor, and
use the [2] knob to change characters.
6. When you’ve specied the le name, press the
[ENTER] button.
A conrmation message appears.
If you decide to cancel, press the [EXIT] button.
When the backup is nished, the screen indicates “Completed!”
If a le of the same name exists, a conrmation screen
(Overwrite?) asks whether you want to overwrite the existing
le.
* Never turn o the power or disconnect the USB ash drive during a
process, such as while the “Executing…” display is shown.
Restoring Backed-Up Data (RESTORE)
Here’s how user data that you backed-up on a USB ash drive can be
returned to the JUPITER-X.
NOTE
All user data are rewritten when you execute the restore operation. If your
JUPITER-X contains important data, assign it a dierent name and back it up to
an USB ash drive before you restore.
1. Connect a USB ash drive.
2. Press the [MENU] button.
3. Use the [1] knob to select “UTILITY,” and then press
the [ENTER] button.
You can also make this selection by using the PAGE [ ] [ ]
buttons instead of the [1] knob.
4. Use the [1] knob to select “RESTORE,” and then press
the [ENTER] button.
5. Use the [1] knob to select the le that you want to
restore.
6. Press the [ENTER] button.
A conrmation message appears.
If you decide to cancel, press the [EXIT] button.
7. To execute, use the [2] knob to select “O K ,” and then
press the [ENTER] button.
When the restore operation is nished, the screen indicates
“Completed. Turn o power.”
8. Turn the power of the JUPITER-X o and then on
again.
* Never turn o the power or disconnect the USB ash drive during a
process, such as while the “Executing…” display is shown.
Convenient Functions
(UTILITY Screen)