28
Editing a Tone (TONE EDIT)
Initializing a Tone (TONE INITIALIZE)
Here’s how to initialize the tone of the current part. The initial state
that is specied diers depending on the model that is selected for
that part.
1. Press the [MODEL BANK] button to switch to tone
select mode.
2. Press the PAGE [ ] button to move the cursor to the
model name.
3. Turn the [2] knob to select the model that you want to
use from its initial state.
4. Press the [WRITE] button.
The WRITE MENU screen appears.
5. Use the [1] knob or [2] knob to select “TONE
INITIALIZE,” and then press the [ENTER] button.
To Next Page
Loading...
