Messages on the Operation Panel..................................................................................301
Messages .......................................................................................................................... 302
[When output, cleaning, and other operations are completed, discard the discharged fluid.] .......... 302
[The time for manual cleaning has arrived.]........................................................................ 302
[The time for wiper replacement has arrived.] .................................................................... 302
[The time for wiper tray cleaning has arrived.].................................................................... 302
[Print head protection mode has activated.] ....................................................................... 302
[Replace the cleaning liquid pouch.] ................................................................................. 303
[Install the cleaning liquid pouch.] ................................................................................... 303
[The time for ink mixing has arrived.] ............................................................................... 303
[Operation of the take-up unit stopped.]............................................................................ 303
[Place the middle pinch rollers over all the grit rollers.] ........................................................ 303
[Install the media clamps correctly.] ................................................................................. 303
[Media clamps could not be detected.] .............................................................................. 304
[The LAN cable is not connected.].................................................................................... 304
[Connection is requiring too much time. Manually setting the IP address will improve the con-
nection speed.]..................................................................................................... 304
[The media could not be detected automatically. Manually set the printing area.] ........................ 305
Error Messages.................................................................................................................... 307
[Ink Pouch Tray Error] ................................................................................................... 307
[Cover Open Error]....................................................................................................... 307
[Media End Error]......................................................................................................... 307
[Pinch Lever Error]....................................................................................................... 308
[Media Loading Error].................................................................................................... 308
[Drain Bottle Error] ...................................................................................................... 308
[Crop Mark Detection Error]............................................................................................ 308
[Unable to Fill Wiper Cleaning Liquid] ............................................................................... 309
[Pinch Roller Error] ...................................................................................................... 309
[Print Head Height Mismatch].......................................................................................... 309
[Insufficient Media Width] .............................................................................................. 309
[Motor Error] .............................................................................................................. 310
[Print Head Dry-out Error].............................................................................................. 310
[Low Temperature Error] ............................................................................................... 310
[High Temperature Error]............................................................................................... 311
[Pump Stop Error] ........................................................................................................ 311
[Cleaning Error (Ink Pouch Tray)] ..................................................................................... 311
[Cleaning Error (Drain Bottle)]......................................................................................... 311
[Take-up Unit Communication Error] ................................................................................. 311
[Service Call] .............................................................................................................. 311
[Software error] .......................................................................................................... 312
Appendix...............................................................................................313
Operations When Moving the Unit .................................................................................314
Preparing to Move the Machine ................................................................................................ 315
Step 1: Removing Media and the Blade Holder....................................................................... 315
Step 2: Discharging the Wiper Tray Cleaning Liquid................................................................. 317
Step 3: Secure the print heads in place using the retainer. ....................................................... 318
Step 4: Reinstalling the Machine ....................................................................................... 319
Main Specifications ..................................................................................................321
Printing/Cutting Area ........................................................................................................... 322
Maximum Area ............................................................................................................. 322
Maximum Printing Area When Using Crop Marks ...................................................................... 323
Media Separation Location during Continuous Printing .............................................................. 324
About the Blade.................................................................................................................. 325
Contents
6
To Next Page
Loading...
