Roland V-1HD+ - Adjusting Input Video; Adjusting Output Video

12
Video Input/Output Settings
Adjusting Output Video
Here’s how to adjust the output image appropriately for the device
that’s receiving the unit’s output.
1. [MENU] button
0
“VIDEO OUTPUT”
0
select “OUTPUT 1”
or “OUTPUT 2,” and press the [VALUE] knob.
2. Use the [VALUE] knob to select a menu item, and press
the [VALUE] knob.
Menu item Explanation
OUTPUT STATUS
Shows the connection status of the OUTPUT
connector.
OUTPUT ASSIGN
Species the output bus that is assigned to
the OUTPUT connector (p. 13).
COLOR SPACE
Species the color space (system for
representing colors in video).
DVI-D/HDMI SIGNAL Species the type of output signal.
BRIGHTNESS Adjusts the brightness.
CONTRAST Adjusts the contrast.
SATURATION Adjusts the saturation.
RED Adjusts the red level.
GREEN Adjusts the green level.
BLUE Adjusts the blue level.
3. Use the [VALUE] knob to edit the value of the setting.
4. Press the [MENU] button several times to close the menu.
MEMO
You can output a test pattern, useful for adjusting the image
quality of a display.
Use the [MENU] button
0
“SYSTEM”
0
“TEST PATTERN” to select
the type of test pattern that will be output.
Adjusting Input Video
Here’s how to adjust the quality of the input video signals.
For the INPUT 4 connector, you can also adjust the scaling.
1. [MENU] button
0
“VIDEO INPUT”
0
select “INPUT 1”–
“OUTPUT 4 (SCALER),” and press the [VALUE] knob.
2. Use the [VALUE] knob to select a menu item, and press
the [VALUE] knob.
INPUT 1–3, INPUT 4 (SCALER)
Menu item Explanation
INPUT STATUS Displays information about the incoming video.
INPUT ASSIGN Selects the video source (p. 22).
FLIP H
If this is “ON,” the video is input with left and right
ipped.
FLIP V
If this is “ON,” the video is input with top and bottom
ipped.
BRIGHTNESS Adjusts the brightness.
CONTRAST Adjusts the contrast.
SATURATION Adjusts the saturation.
INPUT 4 (SCALER)
Menu item Explanation
FLICKER FILTER If this is “ON,” ickering is reduced.
EDID Species the input format (EDID) (p. 11).
ZOOM Adjusts the zoom ratio.
SCALING TYPE Species the scaling type.
MANUAL SIZE H
Adjusts the horizontal size when scaling type is
set to “MANUAL.”
MANUAL SIZE V
Adjusts the vertical size when scaling type is set
to “MANUAL.”
POSITION H Adjusts the position in the horizontal direction.
POSITION V Adjusts the position in the vertical direction.
RED Adjusts the red level.
GREEN Adjusts the green level.
BLUE Adjusts the blue level.
3. Use the [VALUE] knob to edit the value of the setting.
4. Press the [MENU] button several times to close the menu.