Installation
Page 9 AC-115 Hardware Installation and User's Guide
2. Installation
The AC-115 has been designed for easy installation. Only a few
steps are required to install the controller.
In this chapter, you will learn how to mount the controller in
your desired location.
You will learn how to wire the controller to its power source,
which includes attaching the controller to a rechargeable
Lead Acid battery (attaching the controller to a rechargeable
Lead Acid battery was not tested by UL).
Caution:
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type recommended
by the manufacturer. Dispose of used batteries according to
the manufacturer's instructions.
Wiring diagrams are also provided for attaching the controller
to the REX button, Door Monitor switch, Auxiliary Output, and
External 26-Bit Wiegand Compatible readers.
Also covered in this chapter is how to wire the AC-115 to a PC
as a single unit and for use in a system of networked AC-115’s
(wiring for use in a network was not tested by UL).
Note:
For C-UL Listed applications, the unit shall be installed in
accordance with Part 1 of the Canadian Electrical Code.
The topics in this chapter are:
• Mounting the Controller
• Power Wiring
• Typical Lock and Option Wiring
• Reader Wiring
• Connecting a controller to a PC
• Connecting a system to a PC
To Next Page
Loading...
