Programming Instructions
AC-115 Hardware Installation and User's Guide
Page 32
4.14 Changing the Auxiliary Code
1. Enter Programming Mode
• Mode LED will turn orange
2. Press ”25” to enter Menu 25
• The Mode LED will turn red
3. Present a Proximity Card to one of the attached readers or
enter a 1 to 6-digit PIN Code. If your Auxiliary PIN Code is
less than 6-digits long, do not forget to press the “#” key to
confirm your entry after entering your new Programming
Code.
4. If the new Auxiliary Code is unique, the Auxiliary Code will
be updated and the controller will return to Programming
Mode.
• You will hear a short beep
• The Mode LED will turn orange
If the Auxiliary Code entered is not unique, the Auxiliary
Code will NOT be updated and the controller will exit
Programming Mode and return to Normal Mode.
• You will hear a long beep
• The Mode LED will turn green
Note:
There is no factory default Auxiliary Code.
Auxiliary Codes made of all zero’s such as “0”, “00”, ... ,
“000000” will disable the Auxiliary Code Event.
4.15 Changing the Normal / Bypass Code
1. Enter Programming Mode
• Mode LED will turn orange
2. Press ”26” to enter Menu 26
• The Mode LED will turn red
Mode
Door
Oran
e
2 5
Mode
Door
Red
Mode Door
Oran
e
Mode
Door
Green
Mode
Door
Oran
e
2 6
Mode
Door
To Next Page
Loading...
Need help?
General
