Programming Instructions
Page 29 AC-115 Hardware Installation and User's Guide
Code is less than 6-digits long, do not forget to press the
“#” key to confirm your entry after entering your new
Programming Code.
4. If the new Programming Code is unique, the Programming
Code will be updated and the controller will return to
Programming Mode.
• You will hear a short beep
• The Mode LED will turn orange
If the Programming Code entered is not unique, the
Programming Code will NOT be updated and the
controller will exit Programming Mode and return to Normal
Mode.
• You will hear a long beep
• The Mode LED will turn green
Note:
The factory default programming code is 1234.
Programming Codes made of all zero’s such as “0”, “00”,
..., “000000” are not valid Programming Codes and will not
be accepted by the controller.
4.11 Changing the Normal / Secure Code
1. Enter Programming Mode
• Mode LED will turn orange
2. Press ”22” to enter Menu 22
• The Mode LED will turn red
3. Present a Proximity Card to one of the attached readers or
enter a 1 to 6-digit PIN Code. If your Normal / Secure PIN
Code is less than 6-digits long, do not forget to press the
“#” key to confirm your entry after entering your new
Programming Code.
Mode
Door
Oran
e
Mode
Door
Oran
e
2 2
Mode
Door
Red
Mode
Door
Green
To Next Page
Loading...
Need help?
General
