Programming Instructions
Page 33 AC-115 Hardware Installation and User's Guide
? ? ? ? ? ?
3. Present a Proximity Card to one of the attached readers or
enter a 1 to 6-digit PIN Code. If your Normal / Bypass PIN
Code is less than 6-digits long, do not forget to press the
“#” key to confirm your entry after entering your new
Programming Code.
4. If the new Normal / Bypass Code is unique, the Normal /
Bypass Code will be updated and the controller will return
to Programming Mode.
• You will hear a short beep
• The Mode LED will turn orange
If the Normal / Bypass Code entered is not unique, the
Normal / Bypass Code will NOT be updated and the
controller will exit Programming Mode and return to Normal
Mode.
• You will hear a long beep
• The Mode LED will turn green
Note:
There is no factory default Normal / Bypass Code.
Normal / Bypass Codes made of all zero’s such as “0”, “00”,
... , “000000” will disable switching between Normal and
Bypass Mode and vice versa.
4.16 Resetting all Timed Events and Output Settings
to Factory Default Settings
1. Enter Programming Mode
• Mode LED will turn orange
2. Press ”30” to enter Menu 30
• The Mode LED will turn red
• The Door LED will flash red
3. Enter the Programming Code for
confirmation.
If your Programming Code is less than 6-digits long, do not
forget to press the “#” key to confirm your entry after
entering your Programming Code.
Mode
Door
Oran
e
Mode
Door
Green
Mode
Door
Oran
e
3 0
Mode
Door
To Next Page
Loading...
