Programming Instructions
AC-115 Hardware Installation and User's Guide
Page 46
1. Remove power from the AC-115
2. Press the REX button
3. Apply power to the unit with the REX button pressed
4. Release the REX button
You now have 2 minutes to program a new Programming
Code into the controller using the initial default code 1234,
before the controller reverts to the existing code.
5. Enter Programming Mode using the default Programming
Code 1234
6. Use menu “21” to set a new Programming Code
4.34 Replacing a lost Normal / Secure Code
In the event that your Normal / Secure Code is lost and you are
locked in Secure Mode, complete the following procedure to
re-enter Normal Mode so that you may program a new Normal
/ Secure Code.
The AC-115 must be in Secure Mode otherwise this will not
work.
Make sure that the Mode LED is red before proceeding.
1. Remove power from the AC-115
2. Press the REX button
3. Apply power to the unit with the REX button pressed
4. Release the REX button
You now have 2 minutes to enter the default Secure Code
3838 to re-enter into Normal Mode.
Once in Normal Mode you have the ability to enter
Programming Mode and create a new Secure Code. See
“Menu 22” to set a new Normal / Secure Code.
To Next Page
Loading...
Need help?
General
