Programming Instructions
AC-115 Hardware Installation and User's Guide
Page 28
? ? ? ? ? ?
4.9 Resetting all Special Codes to Factory Default
Settings
1. Enter Programming Mode
• Mode LED will turn orange
2. Press ”20” to enter Menu 20
• The Mode LED will turn red
• The Door LED will flash red
3. Enter the Programming Code for
confirmation.
If your Programming Code is less than 6-digits long, do not
forget to press the “#” key to confirm your entry after
entering your Programming Code.
4. If the Programming Code is entered correctly, the Special
Codes will reset to factory default settings. The controller
will exit Programming Mode and enter Normal Mode.
• You will hear a short beep
• The Mode LED will turn green
• The Door LED will stop flashing
If the Programming Code is entered incorrectly, the Special
Codes will NOT reset to factory default settings. The
controller will exit Programming Mode and enter Normal
Mode.
• You will hear a long beep
• The Mode LED will turn green
• The Door LED will stop flashing
4.10 Changing the Programming Code
1. Enter Programming Mode
• Mode LED will turn orange
2. Press ”21” to enter Menu 21
• The Mode LED will turn red
3. Present a Proximity Card to one of the attached readers or
enter a 1 to 6-digit PIN Code. If your Programming PIN
Mode
Door
Oran
e
2 0
Mode
Door
Red
Red
Mode Door
Green
Mode
Door
Green
Mode
Door
Oran
e
2 1
Mode
Door
Red
To Next Page
Loading...
Need help?
General
