Programming Instructions
Page 31 AC-115 Hardware Installation and User's Guide
If the Duress Code entered is not unique, the Duress Code
will NOT be updated and the controller will exit
Programming Mode and return to Normal Mode.
• You will hear a long beep
• The Mode LED will turn green
Note:
There is no factory default Duress Code.
Duress Codes made of all zero’s such as “0”, “00”, ... ,
“000000” will disable the Duress Event.
4.13 Changing the Lock Strike Code
1. Enter Programming Mode
• Mode LED will turn orange
2. Press ”24” to enter Menu 24
• The Mode LED will turn red
3. Present a Proximity Card to one of the attached readers or
enter a 1 to 6-digit PIN Code. If your Lock Strike Code is less
than 6-digits long, do not forget to press the “#” key to
confirm your entry after entering your Programming Code.
4. If the new Lock Strike Code is unique, the Lock Strike Code
will be updated and the controller will return to
Programming Mode.
• You will hear a short beep
• The Mode LED will turn orange
If the Lock Strike Code entered is not unique, the Lock Strike
Code will NOT be updated and the controller will exit
Programming Mode and return to Normal Mode.
• You will hear a long beep
• The Mode LED will turn green
Note:
The factory default Lock Strike Code is 2580.
Lock Strike Codes made of all zero’s such as “0”, “00”, ... ,
“000000” will disable the Lock Strike Code Event.
Mode
Door
Green
Mode Door
Oran
e
2 4
Mode
Door
Red
Mode
Door
Oran
e
Mode
Door
Green
To Next Page
Loading...
Need help?
General
