Rotax 915 i A SERIES - Leak Tests; Checking the Fuel Lines; Checking the Fuel Pressure Regulator

BRP-Rotax
MAINTENANCE MANUAL
LEAK TESTS
General note
ATTENTION
Avoid over-tightening the fastening elements. Use a suitable torque wrench for
all work.
Instruction To check the following steps are necessary:
Step
Procedure
1 Inspect all fuel lines (steel on engine), their connections and unions.
2
Inspect the fuel lines (steel on engine) for sign of chafing.
CHECKING THE FUEL LINES
General note
See Chapter 05–10–00 section Time limit for parts.
Instruction
Step
Procedure
1 Check fuel line (of steel).
CHECKING THE FUEL PRESSURE REGULATOR
General note
Step
Procedure
1
Check the fuel pressure regulator (1) for damages and inspect the general
condition.
2 Perform a leak test.
3
Inspect all connections (2) for secure attachment.
Effectivity: 915 i A Series
Edition 0/Rev. 0
12–20–00
Page 23
December 01 2017