Rotax 915 i A SERIES Maintenance Manual

BRP-Rotax
MAINTENANCE MANUAL
Read out the ECU data memory and check the data for details of diminished functional ca-
pability. Perform the corresponding inspections/repairs depending on the functional de-
fects found.
RETURNING ENGINE TO SERVICE AFTER INFLUENCE BY FIRE
General note An engine after influence by fire must be inspected, repaired or overhauled in accordance
with the BRP-Rotax instructions for continued airworthiness.
Inspection • Inspect all systems for correct functioning.
NNOOTTEE
Prior to the detailed inspection, all parts should be cleaned and inspected for weld
penetration or melted materials.
If an engine was influenced by fire, first a visual inspection of all parts has to be done and
then a hardness test of all mechanical parts must be performed
(e. g.: crankcase, cylinder, cylinder heads etc.).
In most cases an overhaul is necessary, in this regard send the engine without delay to an
authorized ROTAX® overhaul facility for inspection.
EXCEEDING OF MAX. ADMISSIBLE ENGINE RPM
General note
ATTENTION
Any exceeding of the max. admissible engine RPM must be entered by the pilot
into the engine log book stating duration extent of overspeeding and pertinent
detail.
Read out the ECU data memory and check the data for details of increased engine speed.
Perform the corresponding inspections/repairs depending on the functional defects found.
5800 rpm up to
max. 6200 rpm
If the limit was exceeded for max. 1 minute up to 6200 rpm
Step
Procedure
1 No action is required.
5800 rpm up to
max. 6200 rpm
If the limit was exceeded for more than 1 minute up to 6200 rpm.
Step
Procedure
1
Check that the push-rods are straight.
Effectivity: 915 i A Series
Edition 0/Rev. 0
05–50–00
Page 17
December 01 2017

Rotax 915 i A SERIES Specifications

General

Brand	Rotax
Model	915 i A SERIES
Category	Engine
Language	English