BRP-Rotax
MAINTENANCE MANUAL
OIL CHANGE
Instruction
NNOOTTEE
Run engine to warm oil before beginning oil change procedure. To change the oil
the following steps are necessary:
Step
Procedure
1
Crank engine by hand to transfer the oil from the crankcase.
See Chapter 12-20-00 section Purging the oil system.
2 Remove safety wire and oil drain screw from the oil tank, drain the used oil -
see environment note.
3
Replace oil filter at each oil change and inspect the filter insert.
See Chapter 12-20-00 section Oil filter replacement and Inspection of the
filter insert.
4
Dispose of oil filter according to environmental regulations.
5
Install oil drain screw with safety wire.
ATTENTION
Only use brand name oil in accordance with the latest Operators Manual and the
latest Service Instruction “Selection of suitable operating fluids“ of the respec-
tive engine type.
ATTENTION
The engine must not be cranked when the oil system is open. Attention must also
be paid to this before first commissioning (e.g. when assembling the propeller
after correct venting of the oil system).
ATTENTION
Compressed air must not be used to blow through the oil system (or oil lines, oil
pump housing, oil bores in the housing).
ENVIRONMENTAL NOTE
Protect the environment.
Do not harm the environment by spilling oil. Dispose of oil in an environmentally friendly
manner.
Effectivity: 915 i A Series
Edition 0/Rev. 0
12–20–00
Page 27
December 01 2017
To Next Page
Loading...
