BRP-Rotax
MAINTENANCE MANUAL
Figure 7.13: Special tool
1
Oil filter wrench part no. 877620*
2
Cutting tool part no. 877670
*or equivalent
Procedure To remove the oil filter the following steps are necessary:
Step
Procedure
1 Remove used oil filter with oil filter wrench.
2
Clean the contact surface of the oil pump housing with a clean cloth.
Effectivity: 915 i A Series
Edition 0/Rev. 0
12–20–00
Page 29
December 01 2017
To Next Page
Loading...
Need help?
General
