BRP-Rotax
MAINTENANCE MANUAL
Additional
materials
ATTENTION
Use only approved cleaning agents (e.g. kerosine, varsol, etc.) for cleaning all
metal parts.
No.
part no. Description, Application Qty.
1
n.a
Cleaning agents
Do not use lye-based cold cleaner or degreasing
agents. Do not clean coolant or oil hoses with ag-
gressive solutions. Clean off sealing compound res-
idue with sealant remover. Soak combustion
chamber, piston and cylinder head with cleaning
agent and remove combustion residues with a
bronze brush. Very good results have been
achieved with “Clenvex 2000“. It is a solvent-cold
cleaner, free of halogen, on the basis of selected
fuel fractions with tenside and is biologically dispos-
able. Never use caustic or corrosive cleaning
agents.
AR
2
n.a
Preservation oil
This special oil has excellent penetrating capabil-
ities and reaches even tiny gaps, its highly effective
additives protect against corrosion of metal
surfaces
AR
3
n.a
Abrasive pad for surface finishing 3M Scotch-
Brite Multi Flex - very fine or ultra fine
It sold by the meter and used for manual removal of
smaller rust spots or oxidation, especially for opti-
mum ground connections. It is highly suitable for re-
moving LOCTITE from surfaces or threads to make
them metallic clean. Before reapplying LOCTITE,
clean surfaces with nitro thinners or degreasing
agent (CASTROL ZA 30 or OMV-SOFT SOL).
When using solvents, observe the safety regula-
tions for persons and environment regarding use
and proper disposal.
AR
Effectivity: 915 i A Series
Edition 0/Rev. 0
05–00–00
Page 9
December 01 2017
To Next Page
Loading...
