Rotax 915 i A SERIES Maintenance Manual

BRP-Rotax
MAINTENANCE MANUAL
Figure 5.16: Position of the plug screw
1
Plug screw M22x1.5
2
Plug screw M16x1.5
3 Oil filter
Longer than 5 hr. If the engine has been operated longer than 5 hours with engine oil not corresponding
with specification in the Operators Manual the following work is required.
Oil specification not respected
Step
Procedure
1 Remove propeller gearbox.
2 The gearbox must be inspected, repaired or overhauled in accordance with
the BRP-Rotax instructions for continued airworthiness.
3 Carry out detailed inspection of the affected engine components.
4
Oil change.
5
Remove the lowest positioned banjo screw (banjo bolt, plug screw or screw
socket) and drain the remaining oil from the crankcase. Screw in banjo bolt
or plug screw. Tightening torque see Installation Manual 915 i A Series.
6
Replace oil filter.
7
Control of the contact surfaces camshaft / hydraulic valve tappet.
8 Drain oil completely from oil cooler.
9
Drain oil from oil tank.
10
Refill oil tank with oil as specified, refer to Operators Manual.
Effectivity: 915 i A Series
Edition 0/Rev. 0
05–50–00
Page 27
December 01 2017

Rotax 915 i A SERIES Specifications

General

Brand	Rotax
Model	915 i A SERIES
Category	Engine
Language	English