Rottler H85A - Page 15

Section 2 Installation H85A Manual
www.rottlermfg.com
2-4
INSTRUCTING THE OPERATOR:
Note: Rotter employees and representatives per company policy are not permitted to provide end
user of Rottler equipment with any OEM specications for the workpiece that is created by end
user using Rottler equipment.
______ Explain to the customer and operator that at NO time is there to be any software or hardware
other than Windows Auto Update and Rottler installed on this machine. This includes screen
savers, anti-virus software, and any hardware device that installs software on the machine.
Installation of screen savers and anti-virus software can cause dangerous control problems. Any
installation of software or hardware will void the warranty on the machine.
______Explain to the customer and operator that the machine should be hooked up to the Internet
anytime it is on. The software on the machine will automatically connect to our server to send
back useful information on machine status.
______Connect customer supplied Internet to the machine. Verify that the Internet is accessible from the
machine.
______Once the machine has been fully setup and is ready for operation create a Skype account for the
machine following the instructions in the Installation Section of the manual.
______Explain to the customer and the operator how the to log onto Skype and communicate with Rottler
when needed.
______ Computer Viruses will cause the machine control system to become unstable. This may cause
the machine to make uncontrolled moves which could create a dangerous environment for the
machine operator.
______Refer to Chapter 4, Control Denitions of the Machine Manual, Section: Computer and Controller
System Safety. Explain and discuss this section carefully with Owner/Manager/Operator and have
them sign off. Failure to do so will result in the machine warranty being Null and Void.
_______________________________________________________________________
Signature / Title
______Explain to the customer the importance of backing up the block proles to a separate device. Any
computer failure or possible operator input error can result in the loss of all block proles that
were created for the machine. Refer to Chapter 5 of the machine manual for detailed instructions
on backing up and restoring block proles.
______Using the operating manual as a guide explain the function of all buttons.
______Cycle all machine movements and supervise the handling of same by operator.
______Demonstrate the differences of Manual and Auto operation.
______If equipped with the auto rotate xture explain how to set up and operate.
______Explain selecting correct riser blocks for the block to be honed.
______Fully explain the entire Auto Cycle.
______Explain the need to Home the machine each time the hone head is changed or removed and
reinstalled on the spindle.
______Point out safety features to customer and operator. Do not push any buttons without thinking of
safety rst.
______Explain to the customer the proper way to turn the machine off when it is not in use. Do not
leave the machine on overnight. It is important to close all programs followed by shutting down
Windows before turning the main power switch off. Do not turn the main power switch off before
shutting down Windows.