Getting to Know the Access Point Features
SmartCell SC8800-S Outdoor Access Point
Ruckus Wireless Outdoor AP 100.1.0 User Guide, 800-70863-001 Rev A 16
Figure 3 identifies the AP bottom-panel LED locations on the AP. Ta b le 5 describes
these connectors and LEDs.
3
PoE OUT
RJ45 data
connector
Supports 10/100/1000Mbps connections and PoE out. If the AP is
powered using AC or the Ruckus Wireless PoE injector (ordered
separately), then this port can supply 802.3af (15.4W) PoE to a
connected PoE-capable device (for example, an IP-based
surveillance camera). This port alternatively can supply 802.3at
(25.5W) PoE when used with 20m (65.6 ft.) or shorter CAT5e UTP
or better cable.
4
RESET
button
This button resets the AP to its factory defaults, and is mounted
under the
RESET/PoE OUT RJ-45 waterproof gland.
5
PoE IN
RJ45 data
connector
Supports 10/100/1000Mbps connections, connects to the
network and receives Power over Ethernet (PoE) from the Ruckus
Wireless 60W PoE injector.
6
FIBER
port
This waterproof gland allows you to run a fiber-optic cable into the
SC8800-S chassis to an optional fiber modem.
7
LEDs See Figure 3.
Table 4. SC8800-S bottom-panel connectors (Continued)
No. Label Description
To Next Page
Loading...
