SAGEMCOM F@ST 4310 User Manual

5- Information / Configuration
Page 5-112 F@ST 4310 Reference Manual
Sagemcom Broadband SAS document. Reproduction and disclosure prohibited
Auto Channel
Timer (min)
Configure the duration, in minutes, during which the router
must seek the best wireless channel. This option is only
available when the selection of the channel is configured in
Auto (Automatic).
Auto
802.11n/EWC
Select Auto to enable the 802.11n standard and enjoy ideal
speeds for the digital home devices (HDTV, DVD, ...) to 270
Mbit/s.
Auto
Brandwidth Select the bandwidht 20 MHz or 40 MHz. 20 MHz
Control
Sideband
Select in the drop-down list the required value to specify if
the extension channel should be in the Upper or Lower
sideband.
Lower
802.11n Rate
Select in the drop-down list the Physical Layer (NPHY) rate
required.
Note: These rates are only available when the 802.11n
mode is set to Automatic.
Auto
802.11n
Protection
The 802.11g standards provide a protection method in order
802.11g and 802.11b devices to coexist in the same network
without exchanging data at the same time.
• Select Off only if there is a possibility that 802.11b or
802.11g devices will use your wireless network.
• Select Auto for the wireless devices use RTS/CTS to
improve 802.11n performance in mixed 802.11g/802.11b
networks
Auto
Support 802.11n
Client Only
Select On in the drop-down list to enable support for 802.11n
clients only.
Note: In this case, note that 802.11g and 802.11b clients will
not be able to connect to the network.
Off
RIFS
Advertisement
RIFS stands for Reduced Interframe Space. RIFS were
introduced with 802.11n to improve efficiency for
transmissions to the same receiver in which a
SIFS-separated response is not required, such as a
transmission burst.
Auto
OBSS
Co-Existance
Select On in the drop-down list number of cases in which the
primary and the non-primary channels overlap.
Enable
RX Chain Power
Save
Enabling this feature turns off one of the Receive chains. Disable
RX Chain Power
Save Quiet Time
The number of seconds the traffic must be below the PPS
value below before the Rx Chain Power Save feature
activates itself.
10
RX Chain Power
Save PPS
The maximum number of packets per seconds that can be
processed by the WLAN interface for a duration of Quiet
Time, described above, before the Rx Chain Power Save
feature activates itself.
10
Radio Power
Save
Enabling this feature turns off one of the Transmit chains. Disable
Radio Power
Save Quiet Time
The number of seconds the traffic must be below the PPS
value below before the Radio Chain Power Save feature
activates itself.
10
Field Action/Meaning
Default
value

SAGEMCOM F@ST 4310 Specifications

General

Brand	SAGEMCOM
Model	F@ST 4310
Category	Network Router
Language	English