SAGEMCOM F@ST 4310 User Manual

5- Information / Configuration
Page 5-66 F@ST 4310 Reference Manual
Sagemcom Broadband SAS document. Reproduction and disclosure prohibited
5.7.8.1 Queue Config
Object: This menu is used to enable or disable QoS on an interface, and to configure QoS to use policy
maps attached to an interface.
• In the Advanced Setup menu, select Quality of Service then select QoS Queue.
The following screen opens:
Field State
Name Queue entry name
Key
Sequence number allocated by the system, incremented of a unit
to each addition of a QoS Queue.
Interface Name of the network interface configured (8/32 for example).
Scheduler Alg Scheduler algorithm allocated to this queue.
Precedence Priority allocated to "Queue Precedence" from 1 to 3.
DSL Latency
a
a. This field appears only if the DSL mode selected is IPOA.
DSL Latency
PTM Priority PTM priority
Enable
QoS enabled or disabled for this interface.
Note: This status can be amended starting from this window.
Remove
Check the box and click on the [Remove] button to remove the
queue from this list.

SAGEMCOM F@ST 4310 Specifications

General

Brand	SAGEMCOM
Model	F@ST 4310
Category	Network Router
Language	English