SAGEMCOM F@st Plug 502W User Manual

F@st Plug 502W PLC Wireless Router
- 14 -
Note
If multiple network cards are installed on your PC, a window other than the Local
Area Connections Properties window may appears.
Step 3 Double-click Internet Protocol (TCP/IP) and the Internet Protocol (TCP/IP)
Properties window appears.
Step 4 Select Use the following IP address and enter the IP address of the network
adapter. Set the IP address to 192.168. 1.X (‘X’ is a number in the range of 2 to
254) and set the subnet mask to 255.255.255.0.
Configure the default gateway and IP addresses of the DNS servers according to
your actual network, or leave them blank.
After setting the parameters, click OK.

SAGEMCOM F@st Plug 502W Specifications

General

Brand	SAGEMCOM
Model	F@st Plug 502W
Category	Wireless Router
Language	English