Sam4s SPS-300 Series - IRC Options

SAM4s SPS-300 Operator's & Programming Manual v1.34 S-Mode Programming • 121
Hardware Test
Various components of the SPS-300 are tested by using this program.
1. From SERVICE MODE menu press 0 to display the H/W TEST menu:
H/W TEST 
0. TEST PRINTER
1. TEST DISPLAY
2. TEST KEYBOARD
3. TEST MODE
4. TEST RS-232
5. TEST MCR
6. TEST DALLAS
2. From SERVICE MODE menu press PAGE DOWN to display the H/W TEST
menu:
H/W TEST 
7. TEST SD CARD
8. PRINTING PATTERN
3. Press the digit representing the test you wish to perform. See the table that
follows for notes about each test.
Hardware Test Table
TEST NOTES
PRINTER
A printer test pattern is printed. The H/W TEST menu automatically
returns when the test is complete.
DISPLAY
A display test is initiated. The H/W TEST menu automatically
returns when the test is complete.
KEYBOARD
The display indicates: "KEYBOARD TEST". Press any key location
to display its' position. Turn the key lock to end the test.
MODE
Check the mode lock and/or the optional “real” clerk key lock with
this test. As you turn the key lock, the display will show the current
position. The display will also indicate the “real” key that is
inserted. Return the key to the SERVICE position to end the test.