122 • S-Mode Programming SAM4s SPS-300 Operator's & Programming Manual v1.34
TEST NOTES
RS-232
Select LOOP TEST PORT 1-4, Initialize Ethernet, or the IRC Range
test. To loop test port 1-4, a loop back connector must be in place.
MCR Select to test read a magnetic card.
DALLAS Option not available
SD
Insert an SD card and select to run a read/write test. The results will
print. Press CLEAR to exit the test.
PRINTING
PATTERN
ENDLESS PRINTING and LIFE TEST PRINT are factory tests.
Toggle the power switch on and off to end the test.
Memory All Clear
Before you use your SPS-300 Series ECR for the first time, you must perform a memory all
clear to ensure that all totals and counters are cleared and that the default program is installed.
Go to “Clearing Memory” on page 33 to complete this procedure.
Clear All Totals
This selection clears all totals and counters, including the grand total.
1. From SERVICE MODE menu press 1 to display the CLEAR ALL TOTALS
screen:
CLEAR ALL TOTALS
ARE YOU SURE ? N
2. Press the YES/NO key to display Y at the "ARE YOU SURE ?" question. Press
CASH.
3. The display reads: "PLEASE WAIT". The message "ALL TOTAL CLEAR" is
printed and the screen returns to the SERVICE MODE menu.
To Next Page
Loading...
