Sam4s SPS-300 Series - Operations; Operator Display Screen

SAM4s SPS-300 Operator's & Programming Manual v1.34 Getting Started • 35
SPS-345 Memory All Clear
1. Turn the power switch located on the right side of the register to the OFF position.
2. Turn the control lock to the S position.
3. Press and hold the key position where the SUBTOTAL key is located on the default
keyboard layout.
4. Continue to hold the appropriate key while turning the power switch to the ON
position. The message “RAM ALL CLEAR" displays.
5. Press the upper left key of the keyboard, then the lower left key, then the upper right
key, and finally press the lower right key.
Note: In the default configuration, there are 21 double-width PLU keys. Under each
key, the left-most key is inactive and the right-most key is active. The four-key sequence
shown with the default configuration will set the keyboard in the default 21-PLU key
configuration. When the keyboard is expanded, the four-key sequence shown will set
the keyboard in the expanded configuration.
If you wish to build a custom configuration, you will want to perform a memory clear
for the expanded configuration, and then assign each key position individually.
SPS-345
Press and hold the
SUBTOTAL key position
during power-up in S mode.
3
SPS-345
Default
Configuration
(21 PLU Keys)
1
4
3
1
SPS-345
Expanded
(63 PLU keys)
4
2
2