Sam4s SPS-300 Series - System Options - Reference Information

SAM4s SPS-300 Operator's & Programming Manual v1.34 Program Mode Programming • 165
3. When the arrow is pointed at the TAX NUMBER field, enter the number of the
tax you wish to program. (There are four taxes available, enter 1, 2, 3, or 4.)
The arrow will move to the TAX TYPE field.
4. Enter 1 for TAX TABLE programming. The appropriate TAX #
PROGRAMMING screen displays:
TAX #1 PROGRAMMING
FIRST TAX AMOUNT
0.01
NON-TAXABLE AMOUNT
0.10
# OF NON-REPEAT
BREAK 5
# OF REPEAT BRK 3
5. Use the table below as a guide in filling the fields on this screen. After
completing these entries, your screen should look like the screen that follows.
Field Description
FIRST TAX AMOUNT
Enter the first tax amount that is charged.
For this example the entry is 0.01.
NON-TAXable AMOUNT
Enter the highest amount where no tax is
charged. For this example the entry is
0.10.
# OF NON-REPEAT BRK
Enter the number of Non-repeat breaks.
For this example the entry is 5.
# OF REPEAT BREAK
Enter the number of repeat breaks. For
this example the entry is 3.
6. After entering the # OF REPEAT BRK field, the next TAX TABLE PROG.
screen will display. Using the printed copy of your tax table, enter information in
the SALE AMOUNT RANGE fields. Enter the information as it appears on
your tax table. Enter the high amount of the first range where you are prompted.
The low amount of the next range will be computed automatically. After
completing the tax range entries, your screen should look like the following
screen. Note that this screen should look exactly like the corresponding part of
the printed tax table.
TAX TABLE PROGRAMMING
TAX SALE AMT RANGE
0.00 0.00 0.10
0.01 0.11 0.21
0.02 0.22 0.38
0.03 0.39 0.56
0.04 0.57 0.73