122 • Service Mode Programming Sam4s SPS-300 OP Manual v1.35
TEST NOTES
DALLAS Option not available
SD Insert an SD card and select to run a read/write test. The results will
print. Press CLEAR to exit the test.
PRINTING
PATTERN
ENDLESS PRINTING and LIFE TEST PRINT are factory tests.
Toggle the power switch on and off to end the test.
Clear All Totals
This selection clears all totals and counters, including the grand total.
From SERVICE MODE menu press 1 to display the CLEAR ALL TOTALS
screen:
CLEAR ALL TOTALS
ARE YOU SURE ? N
Press the YES/NO key to display Y at the "ARE YOU SURE ?" question. Press
CASH.
The display reads: "PLEASE WAIT". The message "ALL TOTAL CLEAR" is
printed and the screen returns to the SERVICE MODE menu.
To Next Page
Loading...
