260 • Program Mode Programming Sam4s SPS-300 OP Manual v1.35
Machine No.
The machine number is printed on the register receipt. Program a machine number so that any
receipt can be identified with the store or register where the transaction took place. The machine
number may be a different number than the IRC register number programmed in IRC
programming (see "IRC Options" in the "Service Mode Programming" chapter.)
From the PGM control lock position menu, press 00 for MORE. The PROGRAM
MODE page 2 screen displays. Press PAGE DOWN to view the remainder of the
page 2 program options.
From the PROGRAM MODE page 2 screen, press 7 for MACHINE NO. The
MACHINE # PROG. screen displays:
MACHINE # PROGRAM
MACHINE # 0
Type the machine number, up to 5 digits, press CASH.
Training Mode Password
If you wish to use training mode, you must program a password that you will use to enter
training mode. The password may be up to 4 digits long, however, if you choose to use a
password less that for digits, you must enter preceding zeros to complete a 4-digit entry. For
example, if you program the password to be "77", you must type "0077" when entering training.
From the PGM control lock position menu, press 00 for MORE. The PROGRAM
MODE page 2 screen displays. Press PAGE DOWN to view the remainder of the
page 2 program options.
From the PROGRAM MODE page 2 screen, press 9 for TRAINING MODE P/W.
The TRAINING MODE P/W screen displays:
TRAINING MODE PASSWORD
PASSWORD : 0
Type the password, up to 4 digits, press CASH.
To Next Page
Loading...
