Sam4s SPS-320 - Group Programming

146 • Program Mode Programming Sam4s SPS-300 OP Manual v1.35
SPS-345
Descriptor programming by alpha code entry is the default program method for the SPS-345.
The standard configuration of this model has 21 keyboard PLU locations and will not support
descriptor programming by keyboard overlay. However, if the SPS-345 keyboard is expanded to
63 keyboard locations, an option for overlay descriptor programming is available by setting the
program option.
Because SPS-345 key labels are inserted individually underneath the key cap, the overlay
function should accompany the key’s normal function on the key check, perhaps by placing the
alpha function in a corner of the key. The keyboard below shows the placement of alpha
function on the expanded SPS-345 keyboard.
A H O V # ) "
SPACE FEED
JOURNAL
FEED
B I P W $ - ,
SPACE
C J Q X % + .
CAP CLEAR PLU X/TIME
D K R Y ^ = /
DOUBLE
7 8 8
E L S Z & ; <
BACK
4 5 5
SUBTOTAL
F M T ! * : >
1 2 2
CASH
TEND
G N U @ ( ' ?
0 00 .
NOTE: Use the CAPS key to toggle between upper and lower case descriptor options.