Sam4s SPS-320 - Program Scans

240 • Program Mode Programming Sam4s SPS-300 OP Manual v1.35
Endorsement Message
The Endorsement Message is a programming message of up to ten lines of 32 characters that
prints when a check is endorsed on an optional slip printer.
From the LOGO DESC. PROGRAM screen, press 2 to display the
ENDORSEMENT MESG. Screen:
ENDORSEMENT MESSAGE ↓
LINE 1 :

LINE 2 :
LINE 3 :
Using the alpha numeric keyboard overlay (SPS-320/SPS-340, type the descriptor.
For the SPS-345 use the descriptor code method (see page 147.) Each line can be up
to 32 characters. If you make a mistake, press the BACKSPACE key (on the alpha
overlay or enter the backspace code 97 if you are using the descriptor code method)
to erase the previous character. After you have completed typing the first line, press
CASH to accept the new message and advance to the second line, or press CLEAR
to return to the LOGO DESC. PROGRAM screen without making any changes.
Using the same procedure, continue programming each line as necessary. Press
CLEAR at any time to exit. After programming the third line, the next three lines
display:
ENDORSEMENT MESSAGE 
LINE 4 :

LINE 5 :
LINE 6 :
Continue programming all ten lines if necessary. When the last line has been entered,
press CASH to accept the message and return to the LOGO DESC. PROGRAM
screen.